Skip to main content

Add the Generic Service role​

This is Part 2, step 5 of 8 in Install and set up VisualCron on the failover cluster. In this step you add the VisualCron service to the cluster as a Generic Service role. The cluster then watches the service and starts it on another node when needed.

Start the wizard​

To start the wizard, complete the following steps:

  1. In Failover Cluster Manager, select Roles. The list of roles is shown.
  2. Click Configure Role. The Before You Begin page opens.
  3. Click Next. The Select Role page opens.
  4. Select Generic Service.
  5. Click Next. The Select Service page opens.

Choose the service, name and disk​

To choose the service, the network name and the disk, complete the following steps:

  1. Select the VisualCron service.
  2. Click Next. The Client Access Point page opens.
  3. Enter a network name for the role. Clients connect to the VisualCron Server by this name, on the Server port ("16444" by default).
  4. If the network does not use DHCP, enter an IP address for the role.
  5. Click Next. The Select Storage page opens.
  6. Select the VisualCron disk.
  7. Click Next. The Replicate Registry Settings page opens.

Finish the wizard​

To finish the wizard, complete the following steps:

  1. Click Next without adding a registry key. The Confirmation page opens.
  2. Check the settings.
  3. Click Next. The wizard creates the role.
  4. Click Finish.

Result: The role is listed under Roles with the network name you entered, and the VisualCron service runs on the node that owns the role.

note

No registry key needs to be replicated while both nodes use the default settings folder in the shared installation folder. Keep the default settings folder; moving the settings folder of a clustered Server is not covered in this guide.

Next step​

Move the role to another node manually