Install and set up VisualCron on the failover cluster
This is Part 2 of Using VisualCron in a failover cluster. In this part you add a shared disk for VisualCron to the cluster and install VisualCron on it from each node in turn. You then add the VisualCron service to the cluster as a Generic Service role, activate VisualCron and test failover.
Requirements
- Two nodes in a Windows failover cluster; see Install the Windows failover cluster
- An active maintenance or subscription; see Maintenance
- The same VisualCron installation file for both nodes
- VisualCron licensing for the cluster; see Choosing the right license and Activation on a cluster
Steps
- Create the VisualCron disk on the existing target
- Prepare the VisualCron disk on the nodes
- Add the VisualCron disk to the cluster
- Install VisualCron on both nodes in the same shared folder, including the Installed in cluster environment option and the firewall on each node
- Add the Generic Service role
- Move the role to another node manually
- Set up the failover properties of the role
- Activation on a cluster
Test failover
To test failover after Part 2, step 8, complete the following steps:
- In the Client, connect to the Server by the role's network name.
- Note the Jobs on the Server.
- Move the role to the other node. See Move the role to another node manually.
- Connect the Client again by the role's network name.
- Check the activation status. See Information - License.
- Check that the same Jobs and settings are there.
Result: The Server runs on the other node with the same Jobs and settings. If the Server is not activated there, see Activation on a cluster.