Skip to main content

Configure roles and features on the nodes​

This is Part 1, step 2 of 5 in Install the Windows failover cluster. In this step you join every node to the domain and add the Failover Clustering feature. The nodes need no server roles.

Join the node to the domain​

To join a node to the domain, complete the following steps:

  1. On the network adapter that connects the node to the production network, set the DNS server address to the IP address of the domain and storage server on the production network.
  2. Open System Properties.
  3. Select the Computer Name tab.
  4. Click Change....
  5. Under Member of, select Domain.
  6. Enter the domain name.
  7. Click OK.
  8. Enter the credentials of a domain account that can join computers to the domain.
  9. Click OK.
  10. Restart the node when Windows asks you to. The node is a member of the domain.

Select the Failover Clustering feature​

To select the feature, complete the following steps:

  1. In Server Manager -> Dashboard, click Add roles and features. The Add Roles and Features Wizard opens on Before you begin.
  2. Click Next. The Select installation type page opens.
  3. Select Role-based or feature-based installation.
  4. Click Next. The Select destination server page opens.
  5. Select the node you are signed in to.
  6. Click Next. The Select server roles page opens.
  7. Click Next without selecting a role. The Select features page opens.
  8. Select Failover Clustering. If its tools are not installed yet, the Add features that are required for Failover Clustering? window opens.
  9. Click Add Features.

Install the feature​

To install the feature, complete the following steps:

  1. Click Next. The Confirm installation selections page opens.
  2. Check that Failover Clustering and its tools are listed.
  3. Click Install. The feature is installed.
  4. When the installation is complete, click Close.
  5. If the wizard says that a restart is needed, restart the node.

Start the Microsoft iSCSI service​

To start the service, complete the following steps:

  1. Click Start -> Windows Administrative Tools -> iSCSI Initiator.
  2. If Windows says that the Microsoft iSCSI service is not running, click Yes to start it and have it start automatically.
  3. Close iSCSI Initiator.

Repeat these procedures on every node.

Result: Every node is in the domain, has the Failover Clustering feature, and runs the Microsoft iSCSI service.

Next step​

Create an iSCSI virtual disk for the cluster